Ok some more printing projects - Tamsin enquired about printing the 1/100 scale Bergman files off thingiverse at 28mm scale
![]()
![]()
![]()
![]()
Airborne radio jeep, I got the orientation slightly wrong so front wheels need a bit of repair but the next one I do will be fine.
Next Lee asked about the Shermans- the Sherman and Bren Carrier are both printed in resin, the Sherman worked out at just over a £1 the Bren about 0.32p.
Then I did a Kangaroo ram on the fdm - cost 0.38 p and photographed against a commercial one £4.00 retail! Yeah on the fdm you can see some lines and they can be minimised but for me by the time painted etc and on the table they will hardly be visible.
The bastion by the way cost about £15 but I'm going to increase the'infill' which could reduce the cost to around £12 - not bad I think.
